Does anyone use these lights? When you add them in Das4 more than on fixture appear only as one tab so it is impossible to run different effects as you only have one control fader.
Can the lights have separate controls?
Chauvet Beam Bar question
-
- Posts: 3
- Joined: Fri Jan 13, 2017 7:09 pm
- Operating System: Mac OS X
Re: Chauvet Beam Bar question
Hi maburrows251,
i don't have these fixture but when yout look into the manual, you can use it in 4- oder 5-DMX-channel-mode. When you add this fixture in DasLight4, you must select the mode (1 = 5-channel, 2 = 4-channel).
Please look into the manuel
http://www.chauvetlighting.eu/products/ ... ev1_WO.pdf
regards
i don't have these fixture but when yout look into the manual, you can use it in 4- oder 5-DMX-channel-mode. When you add this fixture in DasLight4, you must select the mode (1 = 5-channel, 2 = 4-channel).
Please look into the manuel
http://www.chauvetlighting.eu/products/ ... ev1_WO.pdf
regards
-
- Posts: 61
- Joined: Sat Jul 02, 2016 12:43 pm
- Operating System: Windows
- Location: Germany
Re: Chauvet Beam Bar question
Hi,
first: I found a bug in the fixture .ssl (if you use the chauvet beam bar from the library) beam 2,3,4 are set on beam 1 in the 5ch mode.
I modified this fixture: see attachment if you want to try it remove the extansion .zip
second: if you want to use each fader for each beam you have to select the general button left below.
Hope that helps - let me know.
Thomas
I´m using the windows version
first: I found a bug in the fixture .ssl (if you use the chauvet beam bar from the library) beam 2,3,4 are set on beam 1 in the 5ch mode.
I modified this fixture: see attachment if you want to try it remove the extansion .zip
second: if you want to use each fader for each beam you have to select the general button left below.
Hope that helps - let me know.
Thomas
I´m using the windows version
- Attachments
-
- Chauvet_beam_bar.ssl2.zip
- (11.38 KiB) Downloaded 411 times