Hi i have a question to access th Daslight fun remotely using the I/O ports.
I managed to connect a 4-button push keypad to use it as a matrix swich to select scenes individually.
I did not found how to program the stand alone options to going up and down through the scenes in a same way the small push buttons on the unit acts ? Please advise.
Dry contacts I/O scene change up/down
Re: Dry contacts I/O scene change up/down
Hello,
First of, you need to make sure you have purchased the DVC Fun's Dry Contacts Ports module from the website store.dmxsoft.com.
If that's already done, you'll need to set the Dry Contacts settings for each scene using Daslight4's Scene properties view :
These settings will be written with your show into the interface so you can use them in StandAlone mode.
Hope this helps.
Regards,
First of, you need to make sure you have purchased the DVC Fun's Dry Contacts Ports module from the website store.dmxsoft.com.
If that's already done, you'll need to set the Dry Contacts settings for each scene using Daslight4's Scene properties view :
These settings will be written with your show into the interface so you can use them in StandAlone mode.
Hope this helps.
Regards,
TomHat
--
Daslight Support
Mail : [email protected]
Phone (French) : +33 (0) 616 427 588
Phone (English) : +44 (0) 7 481 811 500
--
Daslight Support
Mail : [email protected]
Phone (French) : +33 (0) 616 427 588
Phone (English) : +44 (0) 7 481 811 500
Re: Dry contacts I/O scene change up/down
Hi,
Yes all is set like you described. I am able to define each scene to set the Dry Contacts.
But the question is: can I select the individual scenes one by one by using only two push buttons (P+ and P-).
Or do I need to assign one button per scene. In my case with 12 scenes and 4 buttons this is not workable.
So how to define the trigger to control these ?
Otherwise I have to solder the circuit board likewise the little black push buttons on the DVC Fun operate now.
Please advise.
Yes all is set like you described. I am able to define each scene to set the Dry Contacts.
But the question is: can I select the individual scenes one by one by using only two push buttons (P+ and P-).
Or do I need to assign one button per scene. In my case with 12 scenes and 4 buttons this is not workable.
So how to define the trigger to control these ?
Otherwise I have to solder the circuit board likewise the little black push buttons on the DVC Fun operate now.
Please advise.
Re: Dry contacts I/O scene change up/down
Hello,
Sadly there is no way to do this using the port triggers. You may do this using the buttons on the interface, though.
Best regards,
Sadly there is no way to do this using the port triggers. You may do this using the buttons on the interface, though.
Best regards,
TomHat
--
Daslight Support
Mail : [email protected]
Phone (French) : +33 (0) 616 427 588
Phone (English) : +44 (0) 7 481 811 500
--
Daslight Support
Mail : [email protected]
Phone (French) : +33 (0) 616 427 588
Phone (English) : +44 (0) 7 481 811 500