Colored Traditional PARs

[Monster1965]

Hi forum,
I'm trying to modulate a quite simple setting, but it causes more problems, than I thought it would.

Situation in real: Many traditional, non-LED PARs at stage. Most of them are equipped with a colour-filter-foil, so they are single colour.

What I like to do: Get them as single-channel PARs to DasLight4 with the square in the right colour and the right colour in the 3D-view.

I created a new ssl2-file, based on the generic PAR. I changed the Intensity-Preset to the colour red. (right-click, properties, specify a colour...). Sounds correct to me and should work. But if I save these setting and reload them, this setting is gone and set back to white.

Is this a bug? Or what did I do wrong? Do anybody know a good solution?

[Benno]

Hi Monster1965, can I check what version of Daslight / 3D viewer you are using? Please can you PM over your fixture profile so I can take a look here in the office? Cheers