End stop positions in Easy View
Posted: Mon May 22, 2017 9:01 pm
Hi there!
I created a moving head profile with the scan library editor for my Stairville MH-100. When I place the fixtures in the visualisation the pan position doesn't fit to the real mh position. The end stops don't match the end stops of the real device. The MH-100s have a total pan radius of 630 degrees, of course the software doesn't know where to start and to stop. My workaround is to rotate the complete MH in Easy View until the beam position matches the real device, but this way its very hard to prepare a show. Is there a way to modify the pan rotation relatively to the 3D models' base?
Thanks for your help!
Chris
I created a moving head profile with the scan library editor for my Stairville MH-100. When I place the fixtures in the visualisation the pan position doesn't fit to the real mh position. The end stops don't match the end stops of the real device. The MH-100s have a total pan radius of 630 degrees, of course the software doesn't know where to start and to stop. My workaround is to rotate the complete MH in Easy View until the beam position matches the real device, but this way its very hard to prepare a show. Is there a way to modify the pan rotation relatively to the 3D models' base?
Thanks for your help!
Chris