End stop positions in Easy View

Real-time 3D simulation

Moderators: TomHat, simonB, Benno

Posts: 1
Joined: Mon May 22, 2017 8:48 pm
Operating System: Windows

End stop positions in Easy View

Postby chriscrown » Mon May 22, 2017 9:01 pm

Hi there!

I created a moving head profile with the scan library editor for my Stairville MH-100. When I place the fixtures in the visualisation the pan position doesn't fit to the real mh position. The end stops don't match the end stops of the real device. The MH-100s have a total pan radius of 630 degrees, of course the software doesn't know where to start and to stop. My workaround is to rotate the complete MH in Easy View until the beam position matches the real device, but this way its very hard to prepare a show. Is there a way to modify the pan rotation relatively to the 3D models' base?

Thanks for your help!
rotatedMHs.PNG (77.95 KiB) Viewed 1281 times

Return to “Virtual 3D Simulator”

Who is online

Users browsing this forum: No registered users and 4 guests