matrix configurator on DVC1

Original software version

Moderators: TomHat, P-Low, simonB, Ksel

Posts: 2
Joined: Mon Jun 08, 2009 11:52 am

matrix configurator on DVC1

Postby sam51279 » Fri May 10, 2013 7:23 am

I'm trying to use matrix configurator in DVC1 but without sucess.
When i add an item, the box message with DMX start adress, stop adress appears. (logical request) but , to bottom i see that there is possibility to choose matrice option ( with line and column) but on my pc, the option stay in grey.
Impossible to activate it?

I would like to control 2 MAtRIX blinder panel (5x5 monochromatic lamps)

Is there a special procedure to activate this option?


Return to “Virtual Controller 1”

Who is online

Users browsing this forum: No registered users and 1 guest