POLL Auto change from HTP / Ltp To AUTO

[SEAMUS]

POLL Auto change from HTP/LTP to AUTO in live mode

[Andre]

POLL Auto change from HTP/LTP to AUTO in live mode

What would trigger the change ?

[SEAMUS]

Trigger would be if the channel was used in any scene then playing that scene would reset the LTP/HTP to Auto.

[Andre]

Trigger would be if the channel was used in any scene then playing that scene would reset the LTP/HTP to Auto.

That is what I thought you meant. Have voted YES.

[SEAMUS]

When I think about it if we had a program button that would add what channels were adjusted on to the scene and then return the channels to auto that would be simpler to work with.

[mikey9206]

or even if we could bind a key for each htp ltp and auto so we can change it at the press of a button

[Andre]

I think it should be kept as simple as possible. i.e. If a scene uses channels that have been overridden by HTP/LTP/IN etc. then if the scene is started it should reset them or at least leave the sliders where they are so you can re-grab them or set to HTP/LTP/IN etc. and it has remembered the slider postion. That would be most useful.

I do not have any problems in resetting the fixtures from HTP/LTP/IN etc back to auto I use the little hand icons above the fixture selection. Each hand does it's own thing.