Hi, I have a problem with my interface DVC2 128-M. When it is connected to the computer with the DVC2 program to work correctly. But if it is connected in mode Standalone the scene saved play the steps but no fade between one step and another.
I seem to have the same problem with a dvc 3 128. The scenes play back fine and fades from step to step when I use the interface with the pc, but jumps from step to step when I use it in standalone mode and trigger the scenes with port 1 and port 2.
It's probably just a smal thing that I've overlooked, but I hope you can help anyway.
Sorry for the late reply. I don't have acces to the interface - it's in an exhibition - but now I've bought another one for testing. But the problem is still the same: No fade between steps in standalone mode.
I've tried the latest DVC3 RC1 from June and like the ealier version the 'Tools/Stand alone' menu is greyed out and I can't select it. Then I tried the latest DVC2 version and updated the firmware. The problem persists. The interface makes nice fades when I play back the scene from the software, but not when I play back in standalone mode.
Are you referring to fade times between steps? Are you using the latest firmware? (open the Hardware Configuration - Tools application included in the RC1 software directory and click on the firmware tab)
If you still cannot find a solution to your problem, send over your show and I'll test it with a DVC3 128 I have here
So if I trigger a scene that ramps channel 1 up and down over 10 seconds, I can then trigger another that ramps channel 3 up and down half way though that also takes 10 seconds, thus over lapping the two ramps in way I desire?