Dry contacts I/O scene change up/down

The new upgradable interface. Ships with 128 channels and can be upgraded to 512 channels, FULL mode and other software via DmxSoft.com

Moderators: TomHat, P-Low, simonB, Ksel

pschurman
Posts: 2
Joined: Sun Jan 19, 2020 10:57 am
Operating System: Mac OS X

Dry contacts I/O scene change up/down

Postby pschurman » Sun Jan 19, 2020 11:04 am

Hi i have a question to access th Daslight fun remotely using the I/O ports.
I managed to connect a 4-button push keypad to use it as a matrix swich to select scenes individually.
I did not found how to program the stand alone options to going up and down through the scenes in a same way the small push buttons on the unit acts ? Please advise.

TomHat
Posts: 853
Joined: Tue Feb 23, 2016 9:11 am
Location: France
Contact:

Re: Dry contacts I/O scene change up/down

Postby TomHat » Mon Jan 20, 2020 10:25 am

Hello,

First of, you need to make sure you have purchased the DVC Fun's Dry Contacts Ports module from the website store.dmxsoft.com.
If that's already done, you'll need to set the Dry Contacts settings for each scene using Daslight4's Scene properties view :
Ports.png
Ports.png (132.96 KiB) Viewed 297 times


These settings will be written with your show into the interface so you can use them in StandAlone mode.

Hope this helps.

Regards,
TomHat
--
Daslight Support

Mail : france@daslight.com
Phone (French) : +33 (0) 616 427 588
Phone (English) : +44 (0) 7 481 811 500

pschurman
Posts: 2
Joined: Sun Jan 19, 2020 10:57 am
Operating System: Mac OS X

Re: Dry contacts I/O scene change up/down

Postby pschurman » Sun Feb 09, 2020 12:10 am

Hi,

Yes all is set like you described. I am able to define each scene to set the Dry Contacts.
But the question is: can I select the individual scenes one by one by using only two push buttons (P+ and P-).

Or do I need to assign one button per scene. In my case with 12 scenes and 4 buttons this is not workable.
So how to define the trigger to control these ?

Otherwise I have to solder the circuit board likewise the little black push buttons on the DVC Fun operate now.

Please advise.

TomHat
Posts: 853
Joined: Tue Feb 23, 2016 9:11 am
Location: France
Contact:

Re: Dry contacts I/O scene change up/down

Postby TomHat » Mon Feb 10, 2020 8:50 am

Hello,

Sadly there is no way to do this using the port triggers. You may do this using the buttons on the interface, though.

Best regards,
TomHat
--
Daslight Support

Mail : france@daslight.com
Phone (French) : +33 (0) 616 427 588
Phone (English) : +44 (0) 7 481 811 500


Return to “DVC FUN”

Who is online

Users browsing this forum: No registered users and 1 guest

cron