DVC 128M Not Controlling all Lights
Posted: Mon Aug 03, 2009 7:04 pm
Hi, I have a dvc128m which was controlling 4 moving heads, 4 pars and a few other lights, All are less than 5 weeks old, everything was working fine until a few days ago, the first light in the dmx stopped responding and caused all other lights to act unusual once i switched off that light all the others were ok, then after an hour another light (moving head) went the same, I cannot for the life of me find whats wrong, its now worse, the address on the fixings just keep changing, i have done this to try to find whats wrong.
1) Changed my laptop and reinstalled the software and drivers. updated the firmware.
2) Changed the light that initially went weird.
3) run a cable directly to the light i have changed.
4) reset the light and made sure the address is correct.
I still cant control the this light, everything was fine at first and i cannot find a problem, could it be the controller, the lights on the dvc128m are flickering away and once i turn off (now two moving heads) the others can be controlled. the heads are genesis move heads by prolight.
PLEASE can anyone help!,
1) Changed my laptop and reinstalled the software and drivers. updated the firmware.
2) Changed the light that initially went weird.
3) run a cable directly to the light i have changed.
4) reset the light and made sure the address is correct.
I still cant control the this light, everything was fine at first and i cannot find a problem, could it be the controller, the lights on the dvc128m are flickering away and once i turn off (now two moving heads) the others can be controlled. the heads are genesis move heads by prolight.
PLEASE can anyone help!,