DMX signal timing - not supported error

GregoryBE · Post by **GregoryBE** » Sun May 31, 2015 1:44 pm

Hello,

We have some fixtures that cannot process a fast dmx timing,
When I go to the hardware manager and try to change the setting to slow, the following error pop ups:
"An error occure while storing Dmx Timing, Functionality not supported by the device"

Screenshot dms settings
https://www.dropbox.com/s/fqui33rx73xocue/Screenshot%202015-05-31%2015.39.36.png?dl=0

Screenshot error:
https://www.dropbox.com/s/aj7tvg5mwm2kipe/Screenshot%202015-05-31%2014.58.25.png?dl=0

Thank you in advance!
Kind regards,
Greg

Benno · Post by **Benno** » Mon Jun 01, 2015 3:43 pm

Hi Greg,

Can I just check your using the latest version of the HardwareManager and Daslight? (Links below)

http://www.daslight.com/downloads/files/DVC3_setup.exe
http://www.dmxsoft.com/global/ftp/hardwaremanager.zip

GregoryBE · Post by **GregoryBE** » Sat Jun 13, 2015 5:08 pm

I did Install the latest daslight from the website. Even tried installing it on another clean PC. Didn't work
The problem seems be gone for now, for no reason, just disconnected and connected a lot.
Saved the hardware manager link so I can test it out in the future, if the problem would occur again.

Thank you for the support!
Kind regards,
Gregory