problem with midi and some fixture

The previous Daslight version

Moderators: TomHat, simonB

lelemari77
Posts: 25
Joined: Sat Mar 17, 2012 6:32 am

problem with midi and some fixture

Post by lelemari77 »

Setting some dmx channel in some fixture control i have problems. If i set the midi, and give the "ok" .... no controls are set and a little red point in the top of the control turn on.
Attachments
midi fixture error.jpg
midi fixture error.jpg (55.41 KiB) Viewed 4562 times
TomHat
Posts: 1380
Joined: Tue Feb 23, 2016 9:11 am
Location: France
Contact:

Re: problem with midi and some fixture

Post by TomHat »

Hello,

Could you try selecting fixtures before you mode the MIDI slider ?

Regards,
TomHat
--
Daslight Support

Mail : [email protected]
Phone (French) : +33 (0) 616 427 588
Phone (English) : +44 (0) 7 481 811 500
darkfire
Posts: 8
Joined: Fri May 29, 2020 6:02 pm
Operating System: Windows
Location: Chesterfield,GB

Re: problem with midi and some fixture

Post by darkfire »

I am also seeing the same problem on some fixtures, with the same red dot at the top

Some options let me map faders & other controls fine however certain controls will allow me to map a function and detects the midi during the mapping process, yet after clicking OK the midi input does nothing, checking the inputs daslight is getting from the midi controller it is getting the correct information yet nothing happens.

I'll record a short video of the problem shortly
Paul
Lighting Design for Wrestling Events & Band's
darkfire
Posts: 8
Joined: Fri May 29, 2020 6:02 pm
Operating System: Windows
Location: Chesterfield,GB

Re: problem with midi and some fixture

Post by darkfire »

Whilst recording a video for this I have found a solution that seems to work, instead of choosing fixture type at the bottom, select general to show all faders, make sure you select the correct universe(this issue only seems to happen when I run more than 1 universe) then right click the fader and set your midi values
Paul
Lighting Design for Wrestling Events & Band's
Post Reply