Dry Contact Ports

[Macarena]

How to use the connector to control a large number of scenes, as in binary use?
Does anyone have a circuit diagram for connecting?
The question is probably about technical support, there are no detailed information in the manual
Thanks

[Macarena]

Dear tech support, how to connect external control to DVC? What logic levels are considered active?

[TomHat]

Hello,

I'm not sure I understand your question. What exactly are you trying to accomplish ?

Regards,

[Macarena]

Scene number 99 - 1100011 or 0011100 ?

[TomHat]

I'd go with 1100011. Did you test it ?

Regards,

[Macarena]

Hi !
Is this the answer from tech support!?

[TomHat]

Hello,
Alright. If I should resume this topic, you sent a screenshot of the "dry contacts" section of the official documentation.
This page gives you an example of how to calculate dry contact ports, based on the binary value of the expedted address : "for example Address 7 is port 1, port 2 and port 3 together" : meaning 1110000. Meaning you need to get port 1, port 2 and port 3 in contact at the same time to generate a port trigger with address 7.

Given that, you are asking how to trigger address 99, which has a binary value of 1100011.

So here comes the tech support's question : Did you test it ?
Did I get your question right or was there some kind of misunderstanding ?

If this doesn't work for you, please contact our support team via this page : https://store.daslight.com/en/support
Our support team will make sure to take all the time needed to figure out what's going wrong.

Regards,