hey guys,
does this artnode automatic detected by daslight to configure outputs?
i do buy the dvc 4 GZM
i dont see the way to do it in the manual to forward the artnet universus to the correct dmx port:
https://www.highlite.com/media/attachments/MANUAL/50804_MANUAL_GB_V1.pdf
SHOWTEC NET-8/5
Re: SHOWTEC NET-8/5
Hello,
Some artnet nodes aren't automatically detected by Daslight4. You might then need to configure your own Node in the software, using the preference window's "Devices" section :
Click "Add Virtual Device", pick the IP address to your ArtNet node and click "OK". Then you'll just need to add and configure as many DMX universes as your ArtNet node can handle.
Hope this helps.
Regards,
Some artnet nodes aren't automatically detected by Daslight4. You might then need to configure your own Node in the software, using the preference window's "Devices" section :
Click "Add Virtual Device", pick the IP address to your ArtNet node and click "OK". Then you'll just need to add and configure as many DMX universes as your ArtNet node can handle.
Hope this helps.
Regards,
TomHat
--
Daslight Support
Mail : [email protected]
Phone (French) : +33 (0) 616 427 588
Phone (English) : +44 (0) 7 481 811 500
--
Daslight Support
Mail : [email protected]
Phone (French) : +33 (0) 616 427 588
Phone (English) : +44 (0) 7 481 811 500
Re: SHOWTEC NET-8/5
Oké, and then my output 1 is automatic universe 1, output 2 universe 2 etc ?
Re: SHOWTEC NET-8/5
It should work like that yes, but you can always decide which Daslight4 universes to set on your node's outputs.
Hope this helps.
Regards,
Hope this helps.
Regards,
TomHat
--
Daslight Support
Mail : [email protected]
Phone (French) : +33 (0) 616 427 588
Phone (English) : +44 (0) 7 481 811 500
--
Daslight Support
Mail : [email protected]
Phone (French) : +33 (0) 616 427 588
Phone (English) : +44 (0) 7 481 811 500
-
- Posts: 1
- Joined: Sun May 17, 2020 7:31 pm
- Operating System: Windows
Re: SHOWTEC NET-8/5
Hello
just to be clear, we need to connect the node to the ethernet port of the computer ? right ?
just to be clear, we need to connect the node to the ethernet port of the computer ? right ?
Re: SHOWTEC NET-8/5
Hello,
It should be enough with the computer and the ArtNet node being connected on the same network.
Regards,
It should be enough with the computer and the ArtNet node being connected on the same network.
Regards,
TomHat
--
Daslight Support
Mail : [email protected]
Phone (French) : +33 (0) 616 427 588
Phone (English) : +44 (0) 7 481 811 500
--
Daslight Support
Mail : [email protected]
Phone (French) : +33 (0) 616 427 588
Phone (English) : +44 (0) 7 481 811 500