Daslight Forum

when I change a dimming-value manually it is set as new value unsing LTP as it should.
If I start a fading-process (new Scene) on that channel, the value is faded properly, but after the fade-in of the Scene the value jumps back to the last manual value instead of keeping the dimming-value as new LTP.

Therefore you cant adjust any value while the Show is running without ruining the whole further Show!
Adjusting a single channel within a running Show can result in immediate Brightness-Changes from 0 to 100% later in the show, that blind everyone if you dimmed that channel manually (we are using 10 kW LED Power)...

Hello,

Sorry to read you're experiencing issues using our software... Which version of Daslight4 are you using ?

Regards,

TomHat wrote:Which version of Daslight4 are you using ?

Aug 02 2018 (18.802.8699.1345)
1.9.1-24139-SVN:36877-(Jul 12 2018)

Right... I'm sorry I haven't been able to reproduce your problem. Could you please send me your showfile along with an explanation on how to reproduce the problem ?

Thanks in advance, and sorry for the delay.

Regards,

It seems that different midi-mappings corrupted the dvc-file, because after deleting and reassigning all midi-controls of the same file the Problem is now different:
Now there are no jumpbacks, but the manual value is not overwritten by a newly selected preset. The Manual midi-value has the effect as it is used as a htp-value. This means you have to completely pull down all changed faders to make preset-changes take effect. If you rise them again you have an immediate brightness-jump because your LTP-Midi-value starts at 0.

i cant upload files because the board tells me .dvc is an invalid Extension. also .zip does not work.

Hello,

Then please send your showfile directly to [email protected]

Regards,