Bug: LTP overrites Fadings, new value isnt stored as LTP
Posted: Sun Nov 18, 2018 6:38 pm
when I change a dimming-value manually it is set as new value unsing LTP as it should.
If I start a fading-process (new Scene) on that channel, the value is faded properly, but after the fade-in of the Scene the value jumps back to the last manual value instead of keeping the dimming-value as new LTP.
Therefore you cant adjust any value while the Show is running without ruining the whole further Show!
Adjusting a single channel within a running Show can result in immediate Brightness-Changes from 0 to 100% later in the show, that blind everyone if you dimmed that channel manually (we are using 10 kW LED Power)...
If I start a fading-process (new Scene) on that channel, the value is faded properly, but after the fade-in of the Scene the value jumps back to the last manual value instead of keeping the dimming-value as new LTP.
Therefore you cant adjust any value while the Show is running without ruining the whole further Show!
Adjusting a single channel within a running Show can result in immediate Brightness-Changes from 0 to 100% later in the show, that blind everyone if you dimmed that channel manually (we are using 10 kW LED Power)...