Hey,
a quick question, is there any way to change or fine-tune the effect parameters after I have generated it or do I need to build a new one every time from scratch if I just want to make a minor tweaks?
Thanks
Changing effect parameters
Re: Changing effect parameters
Hey,
If you just wish to change one static value in all steps at once, you can select all steps in your scene and set said value directly. Otherwise, if it's an effect param you wish to change, ou need to generate a new effect, I'm afraid.
Regards,
If you just wish to change one static value in all steps at once, you can select all steps in your scene and set said value directly. Otherwise, if it's an effect param you wish to change, ou need to generate a new effect, I'm afraid.
Regards,
TomHat
--
Daslight Support
Mail : [email protected]
Phone (French) : +33 (0) 616 427 588
Phone (English) : +44 (0) 7 481 811 500
--
Daslight Support
Mail : [email protected]
Phone (French) : +33 (0) 616 427 588
Phone (English) : +44 (0) 7 481 811 500
Re: Changing effect parameters
Hey,
Thanks for the reply, I noticed that I can save the effect before generating it, which means I can go back to the same parameters and this pretty much solves my issue.
Thanks for the reply, I noticed that I can save the effect before generating it, which means I can go back to the same parameters and this pretty much solves my issue.