Hello,
Maybe somebody has an idea for solving my problem? Here is a simplified description:
I use an Eurolite bar with 4 spots (KLS-40). The bar runs in 24 channel mode, each spot has its own fixture with 6 channels
The start address for the bar is #1,
Spot 1 for musician A has channels #1-#6,
Spot 2 for musician B has channels #7-#12,
Spot 3 for musician C has channels #13-#18,
Spot 4 for musician D has channels #19-#24
I have a lot of scenes which say „Red for musician A“, „Blue for musician D“, etc.
For the next concert the stage setup is totally different. Musician A and D will change their position. It is mechanically not possible to solve the problem by rotating the spots. Is there any easy possibility in Dashlight to „remap“ all commands for spot A (#1-#6) to spot D (#19-#24)?
Thank you!
Micha
Rerouting DMX addresses?
Re: Rerouting DMX addresses?
The solution is simple.
In the patch screen you move spot A to the dmx channels of spot D (for example).
To be able to do so, first move all four spots to dmx channels far away
( f.i. to 201 - 224)
Then move the spot A back to the position that spot D had.
And so on.
The scenes will follow the spotchannels, but your physical spots does not -of course-.
Then you will have a new setup without changing anything in your scenes of physics!!
Good luck!
In the patch screen you move spot A to the dmx channels of spot D (for example).
To be able to do so, first move all four spots to dmx channels far away
( f.i. to 201 - 224)
Then move the spot A back to the position that spot D had.
And so on.
The scenes will follow the spotchannels, but your physical spots does not -of course-.
Then you will have a new setup without changing anything in your scenes of physics!!
Good luck!
Re: Rerouting DMX addresses?
Fantastic, I did not expect, that this is so easy!
Thank you soooo much !!!
Have a nice week,
Micha
Thank you soooo much !!!
Have a nice week,
Micha