I have a number of moving heads. Once I generate 16 steps, I wish to copy them to another moving head and invert some of the pan/tilt settings. Is there a quick way to do this?
Another option is to be able to invert pan/tilt for 2 out of 4 moving heads but only on certain scenes. Thanks!
Copy/Paste steps to another fixture
Re: Copy/Paste steps to another fixture
Hello,
I'm afraid you cannot copy steps from one fixture to another. Steps contain DMX values, with specific addresses. If you copy a step, you will copy all values into a new step, but the addresses won't change.
You cannot copy values from one address to paste them on a different address.
Hope my answer was clear enough.
Regards,
I'm afraid you cannot copy steps from one fixture to another. Steps contain DMX values, with specific addresses. If you copy a step, you will copy all values into a new step, but the addresses won't change.
You cannot copy values from one address to paste them on a different address.
Hope my answer was clear enough.
Regards,
TomHat
--
Daslight Support
Mail : [email protected]
Phone (French) : +33 (0) 616 427 588
Phone (English) : +44 (0) 7 481 811 500
--
Daslight Support
Mail : [email protected]
Phone (French) : +33 (0) 616 427 588
Phone (English) : +44 (0) 7 481 811 500