Greetings All,
I am just starting with Daslight 4 Official, Windows. In installing my first fixture (ADJ Triphase), I ran into a problem. First, the drag and drop of the fixture name does not work, but since this is my first fixture, on address 1, I just selected the fixture, accepted the defauts, and hit the Patch button. Then I get a dialog that says "patching" and it never finishes. The only way out is a reboot.
The fixture is set on address 1 and shows a DMX-connected light. The controller has two steady lights and a flashing green.
Any guidance appreciated. Thanks.
Mark
Stuck on "patching"
Re: Stuck on "patching"
Hi Mark,
sorry but i can't reproduce your problem. Please install the lastest beta version of DasLight4 (15.08.2017 / Win) and try it again. So I did it and you will see this in the next picture (red marked is from me).
- type the fixture name "Triphase"
- drag the founded fixture "triphase led 4ch" to right universum 1 and starting adress 1 (or other adress of your fixture config)
- switch to "EDIT" to create scenes
Hope this will help you.
regards, Martin
sorry but i can't reproduce your problem. Please install the lastest beta version of DasLight4 (15.08.2017 / Win) and try it again. So I did it and you will see this in the next picture (red marked is from me).
- type the fixture name "Triphase"
- drag the founded fixture "triphase led 4ch" to right universum 1 and starting adress 1 (or other adress of your fixture config)
- switch to "EDIT" to create scenes
Hope this will help you.
regards, Martin
Re: Stuck on "patching"
Installing the 4 beta fixed this problem. Thanks.