How to edit the finished (genereted) effect, if it took him a little change such as the size (pan-tilt) or point.
Change all steps - is bad idea, around 100 ...
How to ...
Re: How to ...
Hey,
Unless the modification you want to make is a fixed value over all steps (in which case you can select all your steps and edit the value in palette/fader views), I'm afraid you'll have to regenerate the effect with new values
Regards,
Unless the modification you want to make is a fixed value over all steps (in which case you can select all your steps and edit the value in palette/fader views), I'm afraid you'll have to regenerate the effect with new values
Regards,
TomHat
--
Daslight Support
Mail : [email protected]
Phone (French) : +33 (0) 616 427 588
Phone (English) : +44 (0) 7 481 811 500
--
Daslight Support
Mail : [email protected]
Phone (French) : +33 (0) 616 427 588
Phone (English) : +44 (0) 7 481 811 500
-
- Posts: 69
- Joined: Fri Oct 14, 2016 10:48 am
- Operating System: Mac OS X
- Location: Moldova Tiraspol
Re: How to ...
I found a solution .
Each time there is a need to edit the effect it is necessary to save it ( exаmple.хep file ).
Then you can edit it (resized to fit on the PAN and Tilt) or other parameters .
In my opinion this can be done as a single file for Daslight show01.dvc
This will facilitate the work if you want to move the show from one machine to another. Generating effects (curves, or pixels, etc.) are a single project for the show.
Each time there is a need to edit the effect it is necessary to save it ( exаmple.хep file ).
Then you can edit it (resized to fit on the PAN and Tilt) or other parameters .
In my opinion this can be done as a single file for Daslight show01.dvc
This will facilitate the work if you want to move the show from one machine to another. Generating effects (curves, or pixels, etc.) are a single project for the show.
-
- Posts: 69
- Joined: Fri Oct 14, 2016 10:48 am
- Operating System: Mac OS X
- Location: Moldova Tiraspol
Re: How to ...
How can be assigned to the buttons (RED , White, Yellow) in SHOW mode from the color palette for each separate device?
This can be done ?
This can be done ?
- Attachments
-
- but.png (179.76 KiB) Viewed 6442 times
-
- Posts: 69
- Joined: Fri Oct 14, 2016 10:48 am
- Operating System: Mac OS X
- Location: Moldova Tiraspol
Re: How to ...
'' Color '' ,''gobo'' ''prism'' (not fader!) and other attributes in palette assigned only by MIDI messages , i not found the solutions this task. Assign color(gobo ...) to the selected group - very good then live performance