i have 2 phantom spot hti-150 at home but there is a smal problem i think.
When i try to change the coller it always stays on green.
can it be fixed ?
phantom spot hti-150
-
- Posts: 477
- Joined: Tue Nov 17, 2015 6:48 pm
- Operating System: Windows
- Location: Belgium
- Contact:
Re: phantom spot hti-150
Hi,
Did you check that you have the same mode on the Phantom and in the Daslight patch ?
The mode defines the number of channels used.
Did you check that you have the same mode on the Phantom and in the Daslight patch ?
The mode defines the number of channels used.
Pol Davril
Stage Manager & Technician
Daslight 4 - Version Jan 13 2020
http://www.hsd-productions.be
http://www.exprime-toi.be
Stage Manager & Technician
Daslight 4 - Version Jan 13 2020
http://www.hsd-productions.be
http://www.exprime-toi.be
Re: phantom spot hti-150
the coller did not change in the dvc4 beta software, if i would like to build a show at home ik can't see wish coller i set up.
also my laser won't work on the dvc4, al jb System twin effect laser .
also my laser won't work on the dvc4, al jb System twin effect laser .
Re: phantom spot hti-150
Hey Daansp,
I just tried using the two SSL files you mentioned and my guess is that they have been somewhat badly made. I would advise you to reach the store and send a request for these two files to be corrected here :
Hope this helps.
Regards,
I just tried using the two SSL files you mentioned and my guess is that they have been somewhat badly made. I would advise you to reach the store and send a request for these two files to be corrected here :
Hope this helps.
Regards,
TomHat
--
Daslight Support
Mail : [email protected]
Phone (French) : +33 (0) 616 427 588
Phone (English) : +44 (0) 7 481 811 500
--
Daslight Support
Mail : [email protected]
Phone (French) : +33 (0) 616 427 588
Phone (English) : +44 (0) 7 481 811 500