Hello to everyone!
What do I have to do,to start two identical movingheads ob the Same start adress at the same time?
Thanks to all that try to help.
Greetings,
Olaf
Startadress
Re: Startadress
Hi Olaf, apologies I'm not sure if I fully understand what you mean. If you want your fixtures to have the same DMX address you need to set them to the same address using the dip switches on the actual fixtures. Hope that helps.
Benno
--
Product Support
--
Product Support
Re: Startadress
Hi, Benno!
Thank you for answering.
Maybe I posted it in the wrong forum, but maybe you can help me anyway.
My problem concerns the cameo HydraBeam 400 RGBW. A device with four independant heads. Creating an effect under dvc 4
Gold with the help of the effect generator is nice and works fine.
But under dvc3 only the fourth head will be affected.
Therefore I tryed to "split" the ssl in 4 parts. One Part for each head, and every head with the start Adress 1, because there are no options to assign different start adresses for a single head
Could you please give me a tipp or let me know, why only the last head of the Device works?
Greetings,
Olaf
Thank you for answering.
Maybe I posted it in the wrong forum, but maybe you can help me anyway.
My problem concerns the cameo HydraBeam 400 RGBW. A device with four independant heads. Creating an effect under dvc 4
Gold with the help of the effect generator is nice and works fine.
But under dvc3 only the fourth head will be affected.
Therefore I tryed to "split" the ssl in 4 parts. One Part for each head, and every head with the start Adress 1, because there are no options to assign different start adresses for a single head
Could you please give me a tipp or let me know, why only the last head of the Device works?
Greetings,
Olaf