2 XLRS 3 PIN INTERFACE 1536 CH ??????

stardustgr · Post by **stardustgr** » Wed Mar 23, 2011 5:37 pm

http://www.nicolaudie.com/online_manual ... TE-gY7.htm

THIS IS MY INTERFACE AS U CAN SEE IS 1536 CHAN WITH TWO 3 PIN XLR
AND NOT ONE XLR 3PIN AND ONE 5PIN FROM THE PROGRAM I CAN MAKE 3 LED RED TO LIGHT UP ONE FOR EACH UNIV
HOW CAN I TAKE 3X512 OUT WITH 2 XLR OUTPUTS ONLY?

TONY GREECE

Post by **simonB** » Thu Mar 24, 2011 9:00 am

If you have purchased the DVC2 GZM, it should come with 1x 3pin XLR and 1x 5pin XLR.

Please e-mail me your serial number.

stardustgr · Post by **stardustgr** » Thu Mar 24, 2011 11:31 am

no it has 2 xlr 3 pin
serial number is

Post by **simonB** » Fri Mar 25, 2011 8:44 am

Please e-mail me a photo of the front and rear of the interface. It sounds as though there has been a mistake. We will arrange an RMA over e-mail

stardustgr · Post by **stardustgr** » Fri Mar 25, 2011 9:19 am

sorry what is your mail?

stardustgr · Post by **stardustgr** » Fri Mar 25, 2011 9:44 am

i have upload them here
http://img856.imageshack.us/i/018s.jpg/
http://img838.imageshack.us/i/019iz.jpg/

stardustgr · Post by **stardustgr** » Sat Mar 26, 2011 9:29 am

simon have u seen the photos ?????

stardustgr · Post by **stardustgr** » Sun Mar 27, 2011 7:23 pm

i am i going to get a reply from admin or not :shock:

Post by **simonB** » Mon Mar 28, 2011 11:01 am

Hi Tony

We don't work weekends. Please e-mail me your serial and I will set up an RMA. You can access my e-mail address by clicking the button which says "e-mail" underneath every post I make.

stardustgr · Post by **stardustgr** » Mon Mar 28, 2011 12:00 pm

hi simon i have send you the mail u want just reply and tell my if u get it
thx
tony greece