Daslight Forum

Hello,
I have a DVC33 GOLDZM and I want all devices used in a show to start at specific places (when I have not uploaded any scene, devices have a specific location other than the default).
How can I do this?

Hi There

I'm not sure I understand the question well. You want to make a stand alone scene with your lights in a specific place?

Although my English is bad, I will try to describe two problems.

1. When I do not have any loading Scene the pan and tilt values are: Χ=0 Υ=0 μX=0 μY=0.
I want to have each device specific location:
device-1 X=60 Y=49 μX=120 μY= 130.
device-2 X=80 Y=58 μX=10= μY=40.
device-3 .......
(Τhat is possible to vary the default values ​​of pan and tilt for each device).

2. How can I have a few positions and I call when I need them at some Scene.

hi
the only way to do that in das light is by making a group with blind move
what i mean u will make a group of scenes that the only thing u going to put inside is pan and tilt from ur moving heads and in other group u will put color gobo lamp on and what ever u want. thats the only way that i have found .

Hello I have the dvc 4 gold lying around 1 year already. The problem I am with
this software has this is my default values pan tilt for the scanners are not taken over
this means that the scanners always start at 0.0. That would have to be gotten under control.
What is this setting in the device library for?

Hello,

I am not sure what you mean by "default values pan tilt for the scanners are not taken over". In Daslight4, Pan/Tilt default values don't exist. At best, you could call "default values" :
- values = 0.0 (is the starting state)
- values = 127.127 (is the default "centered" state)

Our fixture profile files do not contain any "default values" for pan/tilt.

I hope I understood your question properly. If not, please feel free to explain with more details.

Regards,