Multiple scenes to a single port?

512 In, 512 out or 2x512 out. Stand Alone memory (512 out)

Moderators: TomHat, simonB, Benno

shefdrummer
Posts: 1
Joined: Wed Sep 19, 2012 9:39 pm

Multiple scenes to a single port?

Postby shefdrummer » Wed Sep 19, 2012 9:43 pm

Hi there - I'm trying to use the Ryger USB-DNX with daslight and don't seem to be able to assign more than one scene to a port (and hence a button on the Ryger unit).

I have a mix of LED par cans, scanners and moving heads and so have split each fixture type into a group and then created scenes for that fixture. FOr example one scene in the PAR cans group for blackout of the pars and a similar scene in the moving heads group.

Now I can trigger more than one scene in the software but when I assign the same port so that one buttion will trigger all blackout scene, only one fixture moves..

So am I limited to a single scene per port and if so I assume the best way is to control all fixture simultaneously from one scene?

Long post but hopefully you get the picture!

simonB
Site Admin
Posts: 1262
Joined: Wed Dec 02, 2009 3:57 pm

Postby simonB » Thu Oct 11, 2012 4:21 pm

it should be possible to trigger 2 scenes from 1 port (I've just tested and it works fine for me). You just need to make sure that the release mode is set to off, or that the release mode is set to group and the scenes are in different groups


Return to “DVC4 GOLD / DVC3 GOLD / DVC2 GOLD”

Who is online

Users browsing this forum: No registered users and 1 guest